Filtered Results

The NI C Series Sound and Vibration Input Module provides dynamic signal acquisition in sound and vibration applications for CompactDAQ and CompactRIO systems.

I have a device with a Delta-Sigma ADC like a NI DSA, C Series or SC Express device and I have noticed the following scenarios. When I set a constant sampling rate on my NI Dynamic Signal Acquisition (DSA) ...

Why do some IEPE and ICP sensors specify Excitation Voltage, and how does that relate to the Compliance Voltage specification for National Instruments’ IEPE products like the NI 4461, NI 4462, NI 4464, ...

I have a TEDS sensor connected to a DAQ device, and I would like to calibrate it. Is the best way to do so in NI MAX or LabVIEW?

I have a NI-9231 module in a cDAQ-9189 chassis. When I try to open NI MAX Test Panel for the NI-9231 module, I get the following error: Error -225202 occured at daqmxcfg_DAQmx Start Task .vi:4410001 ...

I am trying to input or output an impulse or waveform with sharp edges (Square, Triangle, Sawtooth, etc.) from my Dynamic Signal Acquisition (DSA) device. I am seeing an unexpected response, unwanted noise, ...

I am using a C Series module with a Delta-Sigma ADC like a NI 9234 to acquire analog signals using the FPGA in my CompactRIO. When I try to perform the acquisition, I get the following error. Error 65582 ...

I am using a sound and vibration input module to collect data from an IEPE sensor. Do I need to be concerned about matching to the impedance of my cable to the input impedance of my module? I have a transducer ...

GETTING STARTED GUIDE NI 9231 8 AI, ±5 V, 24 Bit, 51.2 kS/s/ch Simultaneous, AC/DC Coupling, IEPE AC Coupling This document explains how to connect to the NI 9231. Note Before you begin, complete the software ...

DATASHEET NI 9231 8 AI, ±5 V, 24 Bit, 51.2 kS/s/ch Simultaneous, AC/DC Coupling, IEPE AC Coupling • 107 dB dynamic range at 51.2 kS/s • <16 μVrms noise • IEPE Open/Short Detection • Smart TEDS sensor compatibility ...

Showing 1-10 of 19 results
1 of 2 pages