Filtered Results

The following figure shows the reset behavior of the cRIO-9066 . Figure 2. Reset Button Behavior Press and hold RESET button for ≥ 5 s Press and hold RESET button for < 5 s Run Mode Safe Mode Press and ...

Put the cRIO-9066 in safe mode and enable the RS-232 serial port by holding the RESET button down for 5 seconds. The STATUS LED starts blinking three times every few seconds. Use the RS-232 serial port ...

Verify that the following items are included in the cRIO-9066 kit. Parent topic: Overview Parent topic: GSG Purpose (cRIO/sbRIO)

This document lists the specifications for the NI cRIO-9066 . The following specifications are typical for the operating temperature range unless otherwise noted. Caution Do not operate the cRIO-9066 in ...

Complete the following steps to install a C Series module. 2 2 3 1 Verify that power is not connected to the I/O connector(s) on the C Series module. If the system is in a nonhazardous location, the cRIO-9067 ...

Complete the following steps to install software on the cRIO-9067 . In MAX, expand your system under Remote Systems. Right-click Software . Select Add/Remove Software to launch the LabVIEW Real-Time Software ...

Before using the cRIO-9067 , you must install the following application software and device drivers on the host computer in this order: LabVIEW 2014 or later LabVIEW Real-Time Module 2014 or later LabVIEW ...

Verify that power is not connected to the I/O connector(s) on the C Series module before you remove a module from the cRIO-9068 . If the system is in a nonhazardous location, the cRIO-9068 can be powered ...

The cRIO-9068 is suitable for use in hazardous locations; , and hazardous locations; and nonhazardous locations only. Follow these guidelines if you are installing the cRIO-9068 in a potentially explosive ...

Showing 1-10 of 2135 results
1 of 214 pages