1LabVIEW FPGA software module is optional unless you need to develop code on FPGA target.
2Additional driver needed to add support for specific C Series Modules (e.g., NI-XNET, NI-DAQmx).
3 NI Measurement & Automation Explorer (MAX) gets installed with the driver (e.g., NI CompactRIO, NI-DAQmx). Therefore, MAX does not have a stand-alone installer.
Note: Always install LabVIEW, LabVIEW Real-Time, and the LabVIEW FPGA Module before installing a device driver. To check what drivers you may need for your C Series module, reference the Software Support for CompactRIO, CompactDAQ, Single-Board RIO, R Series, and EtherCAT page.