From 12:00 AM CDT Sunday, October 17 - 11:30 AM CDT Sunday, October 17, will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

LabVIEW 2016 SoftMotion Module Patch Details

The LabVIEW SoftMotion Module 2016 f2 Patch is available for the LabVIEW 2016 SoftMotion Module. NI recommends this patch for all LabVIEW 2016 SoftMotion Module installations.

This patch will also be available via Update Service. If you already have LabVIEW 2016 SoftMotion Module installed, Update Service will update your computer with the LabVIEW SoftMotion Module 2016 f2 Patch. If you have not yet installed LabVIEW 2016 SoftMotion Module, Update Service will update your computer with LabVIEW SoftMotion Module 2016 f2, which is a full installer that includes both LabVIEW 2016 SoftMotion Module and the f2 patch.

The LabVIEW SoftMotion Module 2016 f2 Patch is cumulative and includes the changes found in the f1 patch. The patch fixes the issues listed in the tables below.

Issues Fixed in the LabVIEW SoftMotion Module 2016 f2 Patch

ID Description
583192 SDI Axes do not implement the Smoothing attribute on reference moves
591142 SDI Axes do not have Home Switch Enabled by default or available in Axis Configuration dialog
607840 SoftMotion Drive Interface (SDI) VIs will not deploy when SoftMotion is not licensed
613626 Position Capture on SDI and UDV Axes do not handle position rollover
615087 SDI Axes can fault when changing move modes
632971 SDI Axes do not work after SoftMotion is re-initialized
643434 SDI Axis position cannot be reset following a home move
667021 SoftMotion Set Plugin Mode will not properly close the SDI plug-in if an error is input
618627 LabVIEW RT crash when running SoftMotion Axes at high Scan Engine rates
639822 LabVIEW RT crash when continuously calling property nodes on different resources in parallel

Issues Fixed in the LabVIEW SoftMotion Module 2016 f1 Patch

ID Description
602055 Wait Until Done VI completes execution before move is complete
600105 Position move setpoint can jump out of range on move start
601616 VxWorks RT Controllers do not work with SoftMotion Remote Axes
595072 Position Error resets without being commanded
602758 SoftMotion Help contains incorrect description when an axis in a coordinate is stopped
601614 Opening FPGA VI with SoftMotion FPGA IP always has a dependency conflict