Table Of Contents

Current Channel Properties (AI)

Last Modified: June 10, 2021

Configure analog input (AI) channel properties to measure current.

For more information on measuring current, refer to the NI-DAQmx Manual.

Property/Section Description
Minimum Value The minimum value you expect to measure before VeriStand performs any scaling or calibration.
Maximum Value The maximum value you expect to measure before VeriStand performs any scaling or calibration.
Input Configuration
Specifies the input terminal configuration to apply to the device channels.
spd-note-note
Note  

If you select any configuration other than Same as device, it overrides the configuration you specify for the device on the DAQ Device Configuration page in System Explorer.

  • Same as device—The same configuration specified for the DAQ device itself. To set the input terminal configuration at the device level, use the Input Configuration pull-down menu on the DAQ Device Configuration page.
  • Default—At run time, NI-DAQmx chooses the default terminal configuration for the channel.
  • RSE—Referenced single-ended mode.
  • NRSE—Non-referenced single-ended mode.
  • Differential—Differential mode.
  • Pseudodifferential—Pseudodifferential mode.
External Shunt Resistance Specifies the external shunt resistance.

Recently Viewed Topics