Table Of Contents

Executing Operations

Version:
    Last Modified: February 1, 2021

    Select the operations you want the Test System Maintenance Software to run by clicking the Gear button (

    ) in the Home page and checking the boxes of the operations you want to perform.

    spd-note-note
    Note  

    You cannot change the settings in the Run Configurations panel while executing operations. Some operations require several minutes to run and cannot be canceled while running. The Verify System Configuration operation always executes before any other operations.

    Test System Maintenance Software performs the following operations:

    spd-note-note
    Note  

    Test System Maintenance Software operations can only be performed on hardware components assembled and shipped by NI as part of an test system configuration.

    1. Verify Components
    2. Renaming Components
    3. Reset
    4. Self Test
    5. Self Calibrate
    6. Get Calibration and Temperature Information
    7. Check Continuity

    Recently Viewed Topics