Table Of Contents

Creating and Configuring the NI 845x Interface

Last Modified: November 6, 2020

Before you begin this procedure, launch the Semiconductor Device Control Add-On and open your project in a large panel.

Complete the following steps to create and configure an NI 845x interface.

  1. Open the Hardware Configuration tab of the Semiconductor Device Control Add-On large panel.
  2. Enter a name for the interface, select NI 845x from the Type drop-down menu, and click Add Interface.
  3. Select the new interface and configure the following hardware settings for the interface.
    1. Select the VISA resource name of the USB-8451 or USB-8452 in the system.
    2. Select the Model indicator to display.
    3. Choose the operating voltage level from the IO Voltage Level drop-down menu.
    4. Choose the I2C pullup resistor type from the I2C Pullup Resistor drop-down menu.

Recently Viewed Topics