Synchronizes USRP RIO devices over the PPS Trig lines.
Synchronization instance. sync.resources is obtained from the Create node.
Signal being synchronized. Because the first block this input encounters is a rising edge detector, the input signal edge is treated as a pulse.
The "start" signal used by the measurement logic. When you use the FPGA Align node, the common reference must be the same clock to which the FPGA clock of the target is locked.
Measurement clock used by the measurement logic. This clock must run at twice the rate of the FPGA Clock, which is the clock that drives the clock-driven loop (CDL) that this node is in. This clock must also derive from the FPGA Clock so that it has a fixed phase relationship. This clock is commonly Data Clock x2.
The FPGA I/O line to receive the measurement signals on. This line is commonly the PPS TRIG IN line.
The FPGA I/O line to send the signal out on.
The same instance that was passed in for sync.resources.
The number of clock cycles of delay that were added by synchronizing the input edge. This value is zero if enable is FALSE. If enable is TRUE, this value is valid only on the master target.
The synchronized input edge if enable is TRUE.
Where This Node Can Run:
Desktop OS: none
Web Server: Not supported in VIs that run in a web application