Configures the custom coefficients for the equalization finite impulse response (FIR) filter on the device.
The FIR filter is designed to compensate the input signal for artifacts introduced to the signal outside of the digitizer. Because this filter is a generic FIR filter, any coefficients are valid.
Handle that identifies the NI-SCOPE instrument session as previously allocated by Initialize With Options .
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Default: No error
The custom coefficients for the equalization FIR filter on the device.
These coefficients should be between +1 and -1. You can obtain the number of coefficients from the Equalization Num Coefficients property. The Equalization Filter Enabled property must be set to True to enable the filter.
Reference to the NI-SCOPE instrument session to pass to the next node in the program.
Error information.
The node produces this output according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.