Home Support NI Product Manuals NI-SCOPE 20.0, 20.1 Manual

Table Of Contents

NI-SCOPE Soft Front Panel and InstrumentStudio

Download Manual | Offline Viewer Required
Version:
Last Modified: June 5, 2020

When you install NI-SCOPE on a 64-bit system, you can monitor, control, and record measurements from supported devices using InstrumentStudio. InstrumentStudio is a software-based front panel application that allows you to perform interactive measurements on several different device types in a single program.

spd-note-note
Note

InstrumentStudio is supported only on 64-bit systems. If you are using a 32-bit system, use your driver's specific soft front panel instead of InstrumentStudio.

InstrumentStudio is automatically installed when you install the NI-SCOPE driver. You can access InstrumentStudio in one of the following ways:
  • From the Windows start menu, select National Instruments» [Driver] Soft Front Panel . This launches InstrumentStudio and runs a soft front panel populated with NI-SCOPE devices.
  • From the Windows start menu, select National Instruments» InstrumentStudio [year] . This launches InstrumentStudio and runs a soft front panel populated with devices detected on your system.
  • From Measurement & Automation Explorer (MAX), select a device and then click Test Panels.... This launches InstrumentStudio and runs a soft front panel for the device you selected.

For more information on using InstrumentStudio, refer to the InstrumentStudio Manual.

Recently Viewed Topics