Table Of Contents
CableSense Signal Start (G Dataflow)
Generates the CableSense signal on all channels of an oscilloscope for which the signal is enabled, as configured by the CableSense Mode property.
You can call this node only during an acquisition. If you call this node while your oscilloscope is not acquiring, NI-SCOPE generates an error.
session in
Handle that identifies the NI-SCOPE instrument session as previously allocated by Initialize With Options.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Default: No error
session out
Reference to the NI-SCOPE instrument session to pass to the next node in the program.
error out
Error information.
The node produces this output according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.