Table Of Contents

Simulating an NI-RFSA Device Using MAX

Version:
    Last Modified: December 19, 2018

    Complete the following steps to create and configure a simulated NI-RFSA device in MAX.
    1. Launch MAX.
    2. Select Devices and Interfaces in the MAX configuration tree, and click Create New in the MAX toolbar.
    3. In the Create New dialog box, select Simulated NI-DAQmx Device or Modular Instrument, and click Finish.
    4. In the Create Simulated NI-DAQmx Device dialog box, expand RF Devices, and select the NI-RFSA device to simulate.
      spd-note-note
      Note

      There is no option to simulate a vector signal analyzer. If you wish to simulate a vector signal analyzer, you must simulate the individual devices that comprise the vector signal analyzer, then associate the devices in MAX or LabVIEW NXG SystemDesigner.

    5. Click OK. The NI-RFSA device appears in the MAX configuration tree with a yellow icon to indicate that it is a simulated device.

    Recently Viewed Topics