Table Of Contents

Associating Hardware Modules in SystemDesigner

Version:
    Last Modified: December 19, 2018

    Before you can program your vector signal analyzer, you must create an association between the individual hardware modules to control them as a single RF device.

    After launching LabVIEW NXG, complete the following steps to associate your hardware modules.
    spd-note-note
    Note

    When you associate modules in SystemDesigner, the changes are automatically reflected in Measurement & Automation Explorer (MAX). You can alternatively associate your modules in MAX.

    1. Open the Live view in SystemDesigner.
    2. On the diagram, select the RF signal downconverter for your vector signal analyzer.
    3. On the Item tab in the Configuration pane, expand Configure vector signal analyzer.
    4. Select the appropriate hardware module from each system component drop-down listbox.
      spd-note-note
      Note

      Select Not Specified if you do not want to associate a specific module with the downconverter. Select External if you want to use an external module, such as a third-party LO or digitizer, with your downconverter.

      Once you associate all the modules, your vector signal analyzer model displays underneath the label of the downconverter on the Live view.

    Recently Viewed Topics