Table Of Contents
Utility
Last Modified: September 5, 2019
Use the Utility nodes to access utility features of NI-HSDIO.
Checks the hardware to determine if the device completed the dynamic data operation or if any errors have occurred.
Programs your hardware for the data operation using the properties you select. Before entering the committed state, most property values are stored in software only; these values have not yet been programmed to the hardware. After the session is committed, the hardware is configured.
Resets the session to its initial state. All channels and front panel terminals are put into a high-impedance state. All software attributes are reset to their initial values.
Resets the device to its initial state and reloads the FPGA. Use this
node
to re-enable your device if it has disabled itself because the device temperature has risen above its optimal operating temperature.
Forces a particular edge, pattern match, or software trigger to occur.
Takes the error code returned by the NI-HSDIO
nodes, interprets it, and returns it as a readable string.
Performs a self-test on the instrument and returns the test results.
Converts unsigned binary data into the digital waveform data type (WDT). Use this
node
to easily create extended state (0, 1, H, L, X, Z) digital waveforms from binary data.
Returns a session reference you can pass to NI-TClk
nodes.