Action

Commits any pending attributes to hardware and starts the dynamic operation.

Pauses execution of your program until the dynamic data operation is completed or the node returns a timeout error.

Stops a running dynamic session.

Transfers waveform data from PC memory to onboard memory.

Initiates a waveform acquisition on channels enabled for dynamic acquisition, waits to acquire the number of samples specified in samples to read, and returns the acquired data.

Immediately reads all PFI channels configured for static acquisition. The least significant bit of read data corresponds to the lowest physical PFI channel number.

Transfers acquired waveform data from device memory to PC memory. This data was previously written to onboard memory by the hardware after the hardware was initiated.

Returns the sample error information from a hardware comparison operation.

Use the Software-Timed PMU nodes to measure and source voltages and currents in your system.

Use the Static nodes to program static acquisition operations.