Table Of Contents

Connecting Signals to Analog Output

Last Modified: December 14, 2018

There are no configuration settings for the analog output channels. All of the analog output channels are single-ended. Each analog output is always referenced to the analog ground (AGND). The following table shows the channel mapping.

Table 1. Analog Output Signal Mapping
Application Board Terminals Signal
Bank A A/AO0 AO 0
A/AO1 AO 1
Bank B B/AO0 AO 0
B/AO1 AO 1
AGND Analog Ground

Use AGND for analog signals only.

Refer to the NI ELVIS III Prototyping Board section on how to access these signals on the NI ELVIS III prototyping board.

Recently Viewed Topics