You can configure channels by using the channel settings.
You can configure some settings directly on the panel. To access additional settings, click the configuration button
on the top right side of the section.
| Setting |
Description |
Operational Limits |
| Status |
Enables or disables data acquisition on the channel. |
- |
| Volts per division |
The vertical scale of the display. |
- |
| Coupling |
Specifies whether to remove the DC component from the signal. Select DC if you want to measure the entire signal. Select AC if you want to remove the DC component from the signal. |
- |
| Probe attenuation |
Amount of attenuation provided by the probe connected to the channel. Select 1X if the probe does not attenuate the input signal. Select 10X if the probe attenuates the input signal by a factor of ten. Probe Attenuation must match the setting of the probe connected to the channel. |
- |
| Vertical offset |
Voltage that the Oscilloscope adds to its original range. For example, if the original range is -25 V to 25 V, and Vertical offset is 25 V, the Oscilloscope's range becomes 0 V to 50 V. |
Range: -25 V to 25 V |
| Vertical position |
Vertical positioning of the waveforms on the graph. This value is not applied to the actual acquired data. Use Vertical position to move the waveform up and down the graph. |
Range: -100 V to 100 V |
The following settings are available on the panel only:
| Setting |
Icon |
Description |
| Include "Off" |
 |
Displays or hides disabled channels on the configuration pane. |
| Expand |
 |
Expands the trace. |
| Shrink |
 |
Contracts the trace. |
on the top right side of the section. 
