Table Of Contents

DAQmx Adjust DSA Calibration (Analog Output » Timebase) (G Dataflow)

Last Modified: July 19, 2019

Adjusts the external calibration constants for the timebase of a DSA device with an adjustable oscillator.

You must first call the DAQmx Setup DSA AO Timebase Calibration node and measure the frequency of the resulting sine wave. Repeat this process until calibration complete returns true.


calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.


measured frequency

measured frequency specifies the measured frequency of the sine wave generated by the device.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.


calibration complete

calibration complete returns TRUE if calibration of the device is complete. If this parameter returns FALSE, repeat the calibration process.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics