Table Of Contents
DAQmx Set Temperature C Series Calibration (G Dataflow)
Specifies the temperature of a C Series device for the current external calibration session.
calHandle in
calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.
temperature
temperature specifies the temperature of the device, in degrees Celsius.
error in
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
calHandle out
calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.
error out
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices
Web Server: Not supported in VIs that run in a web application