Table Of Contents

DAQmx Set Power Up States (Digital » Digital Logic Family) (G Dataflow)

Last Modified: February 26, 2019

Sets the digital logic family to use when the device powers up.


dev in

dev in is the name as configured in MAX of the device to which this operation applies. A DAQmx device name constant lists all devices installed in the system.


logic family

logic family specifies the logic family to set the device to when it powers up. A logic family corresponds to voltage thresholds that are compatible with a group of voltage standards. Refer to device documentation for information on the logic high and logic low voltages for these logic families.

Name Description
2.5 V

Compatible with CMOS signals.

3.3 V

Compatible with LVTTL and LVCMOS signals.

5.0 V

Compatible with TTL and CMOS signals.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


dev out

dev out is the name of the device the operation applied to.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics