Table Of Contents

DAQmx Adjust SCXI Calibration (1540) (G Dataflow)

Last Modified: February 26, 2019

Adjusts the external calibration constants for an SCXI-1540 module.


calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.


input calibration source

input calibration source specifies the input source selection.

Loopback0 Loopback the internal excitation voltage with 0 degree phase shift.
Loopback180 Loopback the internal excitation voltage with 180 degree phase shift.
Ground Connect the channel to ground.

reference voltage

reference voltage specifies in volts the known voltage to use as a reference for calibration.


measured output

measured output specifies in volts the voltage measured at the output of the module.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics