Table Of Contents

DAQmx Auto-Configure cDAQ Sync Connections (G Dataflow)

Last Modified: August 30, 2018

Detects and configures cDAQ Sync connections between devices.

Stop all NI-DAQmx tasks running on the devices prior to running this node, because any running tasks cause auto-configuration to fail.


Auto-configure toggles lines on ports during configuration. Upon completion, all previous configurations are deleted.


dev in

dev in is the name as configured in MAX of the device to which this operation applies. A DAQmx device name constant lists all devices installed in the system.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.



timeout specifies the time in seconds to wait for the device to respond before timing out. If a timeout occurs, no configuration is changed.


dev out

dev out is the name of the device the operation applied to.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.


connections configured

connections configured returns the configured port-to-port connections.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics