Table Of Contents

DAQmx Set SC Express Calibration Accessory Bridge Output (G Dataflow)

Last Modified: May 7, 2018

Configures an SC Express accessory to produce the bridge output specified in volts-per-volt.


calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.


bridge output

bridge output specifies the bridge output in volts-per-volt to be set on the SC Express accessory.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics