Table Of Contents

DAQmx Adjust SC Baseboard Calibration (G Dataflow)

Last Modified: January 11, 2018

Adjusts the external calibration constants for the baseboard of an SC Series device. You must connect a known voltage to the device and specify that voltage with reference voltage.

Use the DAQmx 42xx Calibration nodes to calibrate the full signal path of NI 42xx devices after using this node.


calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.


reference voltage

reference voltage specifies in volts the known voltage to use as a reference for calibration.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics