Table Of Contents
DAQmx Get C Series Calibration Adjustment Points (9203) (G Dataflow)
Returns the reference current values to be used by a reference device to create a reference signal.
calHandle in
calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.
rangeMax
rangeMax specifies the maximum value in the range, in amps.
rangeMin
rangeMin specifies the minimum value in the range, in amps.
error in
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
calHandle out
calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.
adjustmentPoints
adjustmentPoints is the array of adjustment points returned by the node.
error out
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices