Table Of Contents

Connecting the Chamber to a Client PC

Version:
    Last Modified: February 23, 2021

    1. (Chamber revB) Verify that the LED status indicator on the chamber exterior is solid green.
    2. Connect the mmWave OTA Validation Anechoic Chamber to a client PC using a direct connection.
      spd-note-tip
      Tip  

      For best results, dedicate one Ethernet port for the communication and connect the Ethernet cable from that port directly to the client PC to avoid slow hubs or switches.

      spd-note-note
      Note  

      The Ethernet port on the client PC must use the same subnet as the host chamber. For example, if you use the default fixed IP address for the chamber (192.168.2.10), use 192.168.2.1 for the client PC. If you are connecting multiple clients to the host chamber through a switch, each client must have a unique IP address on the same subnet as the host.

    To verify that the chamber is connected to the client PC, open a Command Prompt window and enter "ping 192.168.2.10".

    Recently Viewed Topics