Table Of Contents

Get Status VI

Version:
Last Modified: August 28, 2020

Returns the current status of the measurement.

Session Handle in

Specifies the OTA session.

error in (no error)

Describes error conditions that occur before this node runs. This input provides standard error in functionality.

Start Time

Returns the start time of the measurement, in relative seconds. Use the High Resolution Relative Seconds VI to determine how much time has elapsed.

Session Handle out

Passes a reference of the OTA session to the next VI.

Current Settings

Returns the execution status of the measurement, frequency, polarization, and beam index of the signal.

Execution Status Returns the execution status of the measurement.

Frequency Returns the frequency currently under test.

Polarization Returns the antenna polarization currently under test.

0 The horizontal polarization.
1 The vertical polarization.
2 Both horizontal and vertical polarization.

Beam Returns the beam index specified for the test. The beam index is reserved for indexing measurements based on codebook values.

Current Position

Returns the azimuth and elevation position of the point currently under test.

Elevation Returns the elevation.

Azimuth Returns the azimuth.

Is Done?

Returns TRUE if the measurement stopped.

error out

Error information. This output provides standard error out functionality.

Steps

Returns the total number of points to measure and the current measured point index.

Current Step Returns the current measured point index.

Total Steps Returns the total number of points to measure.


Recently Viewed Topics