Table Of Contents

Configuring Settings in MAX

Version:
Last Modified: August 27, 2020

You must configure and rename your instruments in Measurement & Automation Explorer (MAX) before you begin taking measurements.

  1. Launch MAX.
  2. In the configuration tree, expand Devices and Interfaces to see the list of installed NI hardware. Installed instruments appear under the name of the associated chassis.
  3. Within the Settings section for each instrument, enter the new name in the Name textbox as shown in the following table:
    Instrument Updated Name
    PXIe-6361 DAQ
    PXIe-3622 mmWave_VST
  4. Click Save in the MAX toolbar after you change the name for each instrument.
  5. In the configuration tree, select the PXIe-1095 chassis.
  6. On the Triggers tab, route the following PXI trigger lines between the PXIe-6361 and PXIe-5831:
    1. Set PXI_Trig0 to be away from the PXIe-6361 bus segment to the PXIe-3622 bus segment.
    2. Set PXI_Trig1 to be away from the PXIe-3622 bus segment to the PXIe-6361 bus segment.
  7. Click Save.

Recently Viewed Topics