Table Of Contents

Configure Start Transition VI

Version:
    Last Modified: March 31, 2021

    Configures the start transition of the signal.

    PDM output task in specifies the reference to the PDM output task.

    amplitude profile specifies the type of start transition for the signal.

    0 None (default)—Specifies that no transition profile is enabled for the signal and to transition the signal immediately when the trigger is received. The following figure shows the None amplitude profile applied by this VI.
    1 Half Cosine—Specifies that the start transition follows the shape of a raised, inverted half-cosine function. The following figure shows the Half Cosine amplitude profile applied by this VI.

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

    PDM output task out returns the reference to the PDM output task.

    error out contains error information. This output provides standard error out functionality.


    Recently Viewed Topics