Table Of Contents

Configure Custom Signal (N Ch) VI

Version:
    Last Modified: March 31, 2021

    Configures the properties of the custom signal for the generation task. This VI supports periodic signals. Arbitrary signals are not supported.

    PDM output task in specifies the reference to the PDM output task.

    signal parameters specifies the parameters of the custom signal.

    repetition frequency specifies the frequency, in hertz, at which the custom signal repeats.

    gain specifies the gain of the signal.

    phase specifies the phase, in degrees, of the signal.

    custom data specifies the array values which will load in a lookup table (LUT) that this VI generates using the specified signal parameters.

    The lookup table has the following requirements:
    Number of samples 16384
    Data range ±1.00

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

    PDM output task out returns the reference to the PDM output task.

    error out contains error information. This output provides standard error out functionality.


    Recently Viewed Topics