Table Of Contents

IVI Digital Multimeter Low-Level Measurement (G Dataflow)

Last Modified: September 7, 2018

node_icon
Initiates a measurement.
node_icon
Sends a command to trigger the DMM. Call this node if you pass IVIDMM_VAL_SOFTWARE_TRIG for the Trigger Source parameter of the Configure Trigger Node or the Sample Trigger parameter of the Configure Multi-Point [MP] Node.
node_icon
Returns the value from a previously initiated measurement.
node_icon
Returns an array of values from a previously initiated multi-point measurement. The number of measurements the DMM takes is determined by the values you specify for the Trigger Count and Sample Count parameters of the IviDmm Configure Multi-Point [MP] Node.
node_icon
Aborts a previously initiated measurement and returns the DMM to the Idle state.
node_icon
Takes a measurement value that you obtain from either the Read or Fetch nodes and determines if the value is a valid measurement value or a value indicating that an over-range condition occurred.

Recently Viewed Topics