Table Of Contents

Running a Test

Last Modified: April 2, 2021

Use your configured FlexLogger project to run tests and log data.

Before you begin, configure your hardware device channels and test configuration.
  1. Click RUN to run a test and start logging data. FlexLogger starts logging your test data based on your data logging configuration.

spd-note-note
Note  

All channels are logged except output, variable, and System Resource Monitor channels, which cannot be logged

  1. To pause a running test, click Pause test ( ). When you pause a test, you temporarily suspend data logging, data logging triggers, and time-based events.

spd-note-note
Note  

Value-based events continue running while a test is paused. For more information, refer to Adding an Event.

  1. To resume a paused test, click Resume test.
  2. To stop a running test, click STOP.
After you start logging data, FlexLogger creates a log file that you can view on the Data tab on the Navigation pane. The Data tab contains all of the log files for your project.

Recently Viewed Topics