You can add your current or voltage output to the project by configuring signals in the
Channel Specification. Configure current or voltage generation by enabling the channel and
determining the output settings.
Select one or more channels you wish to configure.
Hover over a channel row and click the Configure gear
The configure gear appears when selecting multiple channels of the same data
type (analog, digital, counter, calculated, and so on). If channels of
different data types are selected, the configure gear will not appear.
Specify the channel name in the Name field.
Select Current or Voltage from
the Physical Generation drop-down menu.
Available output options
vary by device.
If applicable, specify the output Value for the channel
or map to an input channel Source to use as the channel
FlexLogger does not support waveform output. Output signals are software
timed and non-deterministic.
If applicable, specify the Signal Range minimum and
Apply any additional applicable configuration options to the output. Refer to
the Configuring I/O Channels topic for more information on available
FlexLogger does not log