Add a trigger and configure the start and stop conditions for your test.
In your Logging specification document, select a
Start condition for your trigger. Selecting any
Triggering conditions will enable the trigger.
Select from the following trigger start conditions:
begin logging data by clicking the RUN button.
change—Begin logging when the value of the acquisition meets the
specified Value change condition.
logging at a designated date and time.
Optional: Specify a Leading time to include.
You cannot log data before the start of
the test, even if you specify leading time that goes beyond the start of the
Select the required
Stop conditions for your trigger.
Select from the following trigger stop conditions:
stop logging data by clicking the STOP button.
change—Stop logging when the value of the acquisition on a
designated channel meets the specified Value change
elapsed—Stop logging data after a designated duration of time
Optional: Specify a Trailing time to include.
Data logging stops when the test stops,
even if you specify trailing time after a stop trigger.
Click the RUN to enable the triggering.
FlexLogger will begin logging data when the triggering conditions are
met. If the triggering conditions are true when the RUN
button is clicked, logging begins immediately.
A trigger is created when the conditions are set on the Logging specification, but you can enable or disable the trigger from
any project document by using the Triggers toggle in the project toolbar.