Table Of Contents

Configuring Data Rates

Last Modified: March 11, 2020

You can configure the data rate at which your DAQ device acquires data by customizing the data ranges and setting the values for analog (slow, medium, and fast) and digital data rate levels.

Complete the following steps to configure the available data rates for your DAQ device:

  1. Click the Configure Data Rates button on the toolbar, or click Configure from the Data Rate Level pull-down selector.
  2. Specify each frequency in Hz or s (seconds, for intervals) for the desired slow, medium, fast, counter, or digital rates. Available data rate types vary by device.
  3. Click OK to apply the rates for the module.
spd-note-notice
Notice

You can configure any analog input device to use Slow, Medium, or Fast data rates. Counter input modules, however, require the use of the data rate resource that is assigned to the Medium data rate level. If a counter input module is added to a chassis and any module(s) are using the Medium data rate level, you will be prompted to change the data rate on the affected module(s) in the chassis to use the Slow or Fast data rate.


Recently Viewed Topics