Applying J1939 Application Protocol

Apply J1939 Application protocol to your CAN signals.

1. Click Add Signals on the CAN port you want to configure.
2. Select the Database that contains the signals you want to update.
3. Select the Cluster that contains the signals you want to apply J1939 to.
4. Select J1939 from the Application protocol pull-down menu.
5. Select the desired signals from the Signals pane.
   

   Note  

   The Signals pane is organized by frames, and each frame contains a grouping of signals. The Signals Search filter searches for signal names only. To locate a specific frame within the database, search for a signal contained by the frame, select the signal, and then clear the search results.

6. Click Okay.