Table Of Contents

Adjusting Port Interface Settings

Last Modified: March 28, 2019

You can change or configure the port interface settings from within software using the Interface Settings dialog, if necessary.

LIN interfaces are software representations of physical ports. Complete the following steps to adjust the port settings.
  1. Enable Termination, if necessary.
    spd-note-notice
    Notice  

    Improperly configured Termination schemes might result in bus error frames or missed data. Refer to the LIN Cable Termination topic for more information on proper termination.

  2. Use the Baud rate pull-down menu to select an applicable baud rate to all clusters, if necessary.
    spd-note-notice
    Notice  

    The port will use the baud rate defined by the selected database. A Baud rate set to an unsupported value might result in bus error frames or missed data.

  3. (Optional) After the Baud rate is selected, the option to Enable raw frame logging is enabled. Selecting this option will allow FlexLogger to log data without associating the port to a database.

Recently Viewed Topics