Table Of Contents

Unpacking the ECUTS-16000

Version:
    Last Modified: March 29, 2021

    spd-note-note
    Note  

    The ECUTS-16000 shipping crate requires a clearance of at least 3.5 meters (11 ft) in front of the crate to lay out the crate ramp and roll the ECUTS-16000 out of the crate.

    Equipment

    • Flathead screwdriver
    • Scissors, knife, or box cutter
    1. Remove the clamps securing the front panel of the crate using a flathead screwdriver.

    1. Shipping Crate Clamp Release (x10)
    1. Lower the top end of the front panel onto the base of the shipping crate.
    2. Insert the notched top of the front panel into the groove on the bottom of the crate opening to use the front panel as a ramp.
    3. Verify the crate ramp is secure.
    4. Remove the box containing accessories and documentation from the top compartment of the ECUTS-16000 crate.
    5. Inspect the accessories for any physical damage.
    6. Remove the plywood shelf from the top compartment of the ECUTS-16000 crate.
    7. Remove the foam padding securing the ECUTS-16000.
    8. Remove the plywood block located at the bottom of the ECUTS-16000 crate.
    9. Unlock the brakes on the two visible caster wheels on the ECUTS-16000.
    10. Slowly roll the ECUTS-16000 out of the crate and down the ramp using the green, horizontal straps.
    11. Cut and remove the horizontal straps from the ECUTS-16000.
    12. Open and remove the poly antistatic bag from the ECUTS-16000.
    13. Inspect the ECUTS-16000 for any physical damage.
    Contact NI Support if:
    • The ECUTS-16000 is physically damaged.
    • Any additional materials or boxes are physically damaged.
    • The contents of the ECUTS-16000 crate do not match the sales agreement or packing list.

    Recently Viewed Topics