Table Of Contents

Replacing the USB-6363 Multifunction I/O Module

Version:
    Last Modified: March 29, 2021

    Equipment

    • #2 Phillips screwdriver
    • Flathead screwdriver
    1. Power off the ECUTS.
    2. Turn the quarter-turn locks on the left panel of the test rack using the flathead screwdriver.
      • (ECUTS-16000) Two-quarter turn locks
      • (ECUTS-16001) Four quarter-turn locks
    3. Remove test rack side panel.
      • (ECUTS-16000) Remove the left panel
      • (ECUTS-16001) Remove the right panel
    4. Disconnect the VHDCI cables from the USB-6363.
    5. Disconnect the power cable from the USB-6363.
    6. Remove the two screws on the top retention bracket using the #2 Phillips screwdriver.
    7. Remove the USB-6363 from the test rack.
    8. Install the replacement USB-6363 in the bracket.
    9. Screw in the two screws on the top retention bracket using the #2 Phillips screwdriver.
    10. Connect the VHDCI cables to the USB-6363.
    11. Connect the power cable to the USB-6363.
    12. Sit the test rack side panel back into the test rack.
    13. Turn the quarter-turn locks test rack panel using the flathead screwdriver.

    Recently Viewed Topics