Table Of Contents

Powering On

Version:
    Last Modified: March 29, 2021

    spd-note-notice
    Notice  

    To avoid damage to the system, verify that an ITA or field diagnostic tester (FDT) is not connected to the ECUTS before powering on the system.

    1. Verify that the main circuit breaker is in the On position on the PEP.
    2. Confirm that the primary EPO button is not engaged.
    3. Confirm that the programmed temperature shutoff value on the EPO panel thermostat is below the programmed temperature shutoff value.
    4. Flip the main power switch to the right to turn on the ECUTS.

    Recently Viewed Topics