Table Of Contents

Installing and Removing Components on the Mass Interconnect

Version:
    Last Modified: March 29, 2021

    Installing and removing ITA modules or receiver modules on the master interconnect requires a 3/32” ball-end hex bit that is at least 75 mm (3.0 in) long.

    NI recommends a Bondhus 0105 or a McMaster-Carr 6972A16. Because 3/32” sockets or nut drivers are not widely available, adapting this tool to common hand or power tools may require a chuck adapter. NI recommends a Jacobs 30248 or McMaster-Carr 28055A71 chuck adapter. Refer to the Virginia Panel Corporation 9025 User Manual for torque values.


    Recently Viewed Topics