Table Of Contents

(ECUTS-16001) Replacing the Ethernet Switch

Version:
    Last Modified: March 29, 2021

    Equipment

    • #1 Phillips screwdriver
    • #2 Phillips screwdriver
    1. Power off the ECUTS-16001.
    2. Open the rear cabinet door.
    3. Disconnect the ethernet cables from the ethernet switch.
    4. Disconnect the power from the ethernet switch by removing the combicon connector.
    5. Remove the screws from the bracket securing the ethernet switch to the test rack using the #2 Phillips screwdriver.
    6. Remove the ethernet switch from the mounting bracket using the #1 Phillips screwdriver.
    7. Install the replacement ethernet switch to the mounting bracket.
    8. Replace the screws to the bracket securing the ethernet switch to the test rack using the #2 Phillips screwdriver.
    9. Connect the power to the ethernet switch by replacing the combicon connector.
    10. Connect the ethernet cables to the ethernet switch.
    11. Close the rear cabinet door.

    Recently Viewed Topics