Table Of Contents

Auto Start

Version:
    Last Modified: May 15, 2018

    • The auto start function starts the User Program under the following conditions:
      • When you cycle external power to the module
      • After successful download of a User Program
      • On power up
      • When you change operating modes
    • Auto start is enabled by default. You can disable or enable auto start with the Auto start checkbox on Module and Diagram tab.
    • If auto start is enabled, the User Program starts when the module changes to Verification Mode after a successful download.
    • If auto start is disabled, users must restart the User Program from the Start Program Method in LabVIEW.
    • Auto start disables when the User Program triggers Fail-safe Mode.
      spd-note-tip
      Tip  

      When the User Program triggers Fail-safe Mode, auto start disables, preventing Fail-safe Mode loops and allowing you to download a new User Program.

    • Cycling external power twice after the module goes into Fail-safe Mode re-enables auto start.
    • Auto start does not disable when automatic self-diagnostics trigger Fail-safe Mode.

    Recently Viewed Topics