DIAdem DAC

DIAdem DAC

Use DIAdem DAC to create a block diagram that you can use for measurement and for open and closed loop control. You create the block diagram in the DIAdem DAC workspace. To do this, you open the function groups and select the function blocks you need, and then you use buses to connect the blocks. After you double-click a function block, you can set the parameters for the block.

DIAdem DAC supports Single value processing and Packet processing during a measurement. Use the following functions:

	Use the System function group to insert into a block diagram, blocks that you use to define a system clock and to save measured data.
	Use the Driver Inputs function group to insert into a block diagram, blocks that you use to acquire signals that access measurement hardware or that access external devices.
	Use the Simulation Inputs function group to insert into a block diagram, blocks that you can use to simulate measured values.
	Use the Scaling function group to insert into a block diagram, blocks that you can use to linearize data.
	Use the Processing function group to insert into a block diagram, blocks that you can use to apply mathematical functions to data signals and control signals.
	Use the Control function group to insert into a block diagram, blocks that you use to control measurements.
	Use the Alarm System function group to insert into a block diagram, blocks that you can use to display and to record when limits are exceeded.
	Use the Display Instruments function group to insert into a block diagram, blocks that you can use to display measured values online.
	Use the Driver Outputs function group to insert into a block diagram, blocks that you use to output signals and to access measurement hardware or to access external devices.
	Use the Simulation Outputs function group to insert into a block diagram, blocks that you can use to simulate measured value output.
	Use the Signal Processing (Packet Processing) function group to insert basic packet processing blocks into a block diagram.
	Use the Signal Analysis (Packet Processing) function group to insert into a block diagram, basic blocks for mathematical processing of packet data.
	Use the Display and I/O (Packet Processing) function group to insert into a block diagram, the basic blocks for displaying packet data and for the input and output of packet data.
	Use the Driver (Packet Processing) function group to insert packet processing blocks from hardware drivers, into a block diagram.