Generates the CableSense signal on all channels of an oscilloscope for which the signal is enabled, as configured by the CableSense Mode property.

Note The input impedance of the channel(s) to convey the CableSense signal must be set to 50 Ω.

You can call this VI only during an acquisition. If you call this VI while your oscilloscope is not acquiring, NI‑SCOPE generates an error.

Supported Devices


icon

Inputs/Outputs

  • civrn.png instrument handle —

    instrument handle identifies a particular instrument session.

  • cerrcodeclst.png error in —

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

  • iivrn.png instrument handle out —

    instrument handle out has the same value as the instrument handle.

  • ierrcodeclst.png error out —

    error out contains error information. This output provides standard error out functionality.