Connecting the sbRIO-9637 to Power
- Updated2023-02-20
- 1 minute(s) read
Connecting the sbRIO-9637 to Power
The NI sbRIO device requires a 9 VDC to 30 VDC external power supply. The NI sbRIO device filters and regulates the supplied power and provides power for RMCs.
Note Refer to the
Power Requirements section of the
NI sbRIO-9637 Specifications
for the complete power requirement specifications.
Note Refer to the
Power Requirements section of the
NI sbRIO-9637 User Manual
for formulas and examples for calculating power requirements for different configurations and application types.
Note Refer to the
Power Requirements section of the
NI sbRIO-9637 User Manual
for proper wiring of the power cable assembly.
Complete the following steps to connect a power supply to the device.
Caution Do not mate or unmate the power supply connectors while power is applied.
- Ensure that your power supply is powered off.
- Insert the power connector plug into the power connector receptacle of the NI sbRIO device until the connector latches into place.
- Turn on the power supply.