STATUS LED Indicators
- Updated2024-05-07
- 1 minute(s) read
STATUS LED Indicators
| LED Pattern | Indication |
|---|---|
| Blinks twice and pauses | The sbRIO-9607 is in safe mode. Software is not installed, which is the factory default state, or software has been improperly installed on the sbRIO-9607. An error can occur when an attempt to upgrade the software is interrupted. Reinstall software on the sbRIO-9607. Refer to the Measurement & Automation Explorer (MAX) Help for information about installing software on the sbRIO-9607. |
| Blinks three times and pauses | The sbRIO-9607 is in user-directed safe mode, or the sbRIO-9607 is in install mode to indicate that software is currently being installed. This pattern may also indicate that the user has forced the sbRIO-9607 to boot into safe mode by pressing the reset button for longer than five seconds or by enabling safe mode in MAX. Refer to the Measurement & Automation Explorer (MAX) Help for information about safe mode. |
| Blinks four times and pauses | The sbRIO-9607 is in safe mode. The software has crashed twice without rebooting or cycling power between crashes. |
| Continuously blinks | The sbRIO-9607 has not booted into NI Linux Real-Time. The sbRIO-9607 either booted into an unsupported operating system, was interrupted during the boot process, or detected an unrecoverable software error. |
| On momentarily | The sbRIO-9607 is booting. No action required. |
| Off | The sbRIO-9607 is in run mode. Software is installed and the operating system is running. |