Arb:Write Waveform Burst Detection:Enabled Property

Arb:Write Waveform Burst Detection:Enabled Property

Short Name: Write Waveform Burst Detection

Property of niRFSG

Enables the detection of burst start and burst stop locations in the waveform. Set this property to Enable before writing a waveform to NI-RFSG memory for detecting bursts. You can read the detected burst start and burst stop locations using niRFSG Get Waveform Burst Start Locations and niRFSG Get Waveform Burst Stop Locations VIs respectively.

Note  When you download a waveform using niRFSG Read and Download Waveform From File (TDMS) VI and if RF Blanking property is enabled, you must set the Write Waveform Burst Detection property to Disable.

Note  For PXIe-5830/5831/5832, the RF Blanking reserves a PXI trigger line. If you are calling any niRFSG Reset or niRFSA Reset on the same device, NI recommends calling it before committing blanking properties. Alternatively, you can call niRFSG Reset With Options or niRFSA Reset With Options. Select Routes in the steps to omit parameter.

Default Value: Disable

Supported Devices: PXIe-5820/5830/5831/5832/5840/5841/5842

Remarks

The following table lists the characteristics of this property.

Datatype
Permissions	Read/Write
High-level VIs	N/A
Channel-based	Yes
Resettable	Yes