RF:Advanced:Exported Pulse Modulation Event Active Level Property
- Updated2025-02-03
- 1 minute(s) read
RF:Advanced:Exported Pulse Modulation Event Active Level Property
Short Name: Exported Pulse Modulation Event Active Level
Property of niRFSG
Specifies the active level of the exported Pulse Modulation Event. When `NIRFSG_ATTR_PULSE_MODULATION_ENABLED` is Enabled, `NIRFSG_ATTR_PULSE_MODULATION_ACTIVE_LEVEL` is `NIRFSG_VAL_ACTIVE_HIGH`, `NIRFSG_ATTR_EXPORTED_PULSE_MODULATION_EVENT_OUTPUT_TERMINAL` is `PulseOut`, and this property is `NIRFSG_VAL_ACTIVE_HIGH`, then the Pulse Modulation Event will transition from Low to High after the the Pulse In signal is set to logic high, and the RF Output has settled. To set this property, the NI-RFSG device must be in the Configuration state.
Supported Devices: PXIe-5842
Default Value: Active High
| Active High (9000) |
When the trigger has started, the active level is high. |
| Active Low (9001) |
When the trigger has started, the active level is low. |
Remarks
The following table lists the characteristics of this property.
| Datatype |  |
| Permissions | Read/Write |
| High-level VIs | N/A |
| Channel-based | Yes |
| Resettable | Yes |