Specifies the interframe spacing for signal generation. If you set the Idle Interval Mode property to Split, the WLAN Generation places half of the interframe spacing on either side of the burst in the generated waveform. If you set the Idle Interval Mode property to Post Burst, the WLAN Generation places the interframe spacing at the end of the waveform. The waveform contains zeros for the duration of the interframe spacing. This value is expressed in seconds.

Tip For higher values of idle interval, LabVIEW may run out of memory. For a large idle interval, you can create a small idle waveform and generate the waveform multiple times using scripting.

The default value is 100 microseconds. Valid values are 0 to 1, inclusive.

Remarks

The following table lists the characteristics of this property.

Short Name Idle Interval (s)
Data type cdbl.png
Permissions Read/Write
High-level VIs niWLANG Set Idle Interval
Resettable No